Адаптация Maple Mini под FX2N
Re: Адаптация Maple Mini под FX2N
Modbus Slave Error with Modbus Poll
- Вложения
-
- STM32 PLC Modbus Test Error.PNG (43.86 KiB) 1646 просмотра
-
- STM32 PLC Modbus Test Error.PNG (43.86 KiB) 1646 просмотра
Re: Адаптация Maple Mini под FX2N
Hi qamar.
Sorry for delay with answer. On you screenshot you are not receive answer.
Please, try to change RX and TX wire on you connector.
For communication you not need any license. Also,this version demo- without posibility to licensing.
With best regards, support team.
Sorry for delay with answer. On you screenshot you are not receive answer.
Please, try to change RX and TX wire on you connector.
For communication you not need any license. Also,this version demo- without posibility to licensing.
With best regards, support team.
Re: Адаптация Maple Mini под FX2N
Hi i have already tried that already both ways it seems like something wrong with the PLC configuration tool, or may be iam missing something int he settings could please send me some screen shot on how to setup modbus points simple test.
Thanks
Qamar.
Thanks
Qamar.
Re: Адаптация Maple Mini под FX2N
Also i want to know is it possible to setup "Analog input" and "Analog output" with this Firmware version?
Regards,
Qamar.
Regards,
Qamar.
Re: Адаптация Maple Mini под FX2N
Also, you carefully read readme file on the github, where you download this firmware?
Here copy of this text -
Software Implementation of PLC with STM32 "bluepill" hardware.
Version G34 -
For now you can use all 8000 steps in you program. This version not for field of industral use, and now you can use only 4 input and 4 output. Also you can use all posibility for master and slave modbus, but only 50 requests.
From this version modbus slave adress is fixed - 111 for UART1 and 112 for UART2.
Also you can program device from any port( not only USB VCP), connected as modbus slave.
Please, use modbus address 111 and 112. This can solve you problem.
With best regard, support team.
Here copy of this text -
Software Implementation of PLC with STM32 "bluepill" hardware.
Version G34 -
For now you can use all 8000 steps in you program. This version not for field of industral use, and now you can use only 4 input and 4 output. Also you can use all posibility for master and slave modbus, but only 50 requests.
From this version modbus slave adress is fixed - 111 for UART1 and 112 for UART2.
Also you can program device from any port( not only USB VCP), connected as modbus slave.
Please, use modbus address 111 and 112. This can solve you problem.
With best regard, support team.
Вернуться в «Системы на основе STM32»
Кто сейчас на форуме
Количество пользователей, которые сейчас просматривают этот форум: нет зарегистрированных пользователей и 0 гостей